Mpls Traffic-Eng Attribute-Flags - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
mpls traffic-eng attribute-flags
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
mpls traffic-eng attribute-flags bitmask
no mpls traffic-eng attribute-flags
Command introduced before JunosE Release 7.1.0.
Specifies attributes for the interface for traffic engineering. The attributes are compared
with tunnel affinity bits to determine links eligibility for the tunnel. The no version restores
the default value, 0x0.
bitmask—Mask that sets the attributes, a value in the range 0x0–0xFFFFFFFF
Interface Configuration, Subinterface Configuration
Chapter 13: M Commands
1417
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 and is the answer not in the manual?