Mpls Ldp Sync - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

mpls ldp sync

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
From Interface Configuration mode and Subinterface Configuration mode:
[ no ] mpls ldp { isis | ospf } sync
From Router Configuration mode for IS-IS:
mpls ldp sync [ level-1 | level-2 | level-1-2 ]
no mpls ldp sync
From Router Configuration mode for OSPF:
mpls ldp sync [ areaId | areaIdInt ]
no mpls ldp sync
Command introduced in JunosE Release 8.1.0.
In Interface Configuration mode, synchronizes LDP with the IGP on the current interface.
The no version removes the configuration for the interface.
In Router Configuration mode, synchronizes LDP with the IGP on all of the protocol's
interfaces, on all interfaces in the specified level (IS-IS), or on all interfaces in the specified
area (OSPF). The no version removes the configuration for all qualifying interfaces.
By default, LDP synchronization is not configured.
LDP—IGP synchronization must be configured on both sides of a link to be effective and
avoid asymmetric link costs. In addition, LDP-IGP synchronization is effective only when
alternate links with adequate bandwidth are available in the network.
level-1—Enables synchronization with LDP on all IS-IS level 1 interfaces
level-1-2—Enables synchronization with LDP on all IS-IS level 1-2 interfaces
level-2—Enables synchronization with LDP on all IS-IS level-2–only interfaces
areaId—OSPF area ID in IP address format
areaIdInt—OSPF area ID as a decimal value in the range 1–4294967295
Interface Configuration, Router Configuration, Subinterface Configuration
Chapter 13: M Commands
1365