Ip Nat Outside Source List - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

JunosE 11.2.x Command Reference Guide A to M

ip nat outside source list

Syntax
Release Information
Description
Options
Mode
868
ip nat outside source list accessListName pool poolName
no ip nat outside source list accessListName
Command introduced before JunosE Release 7.1.0.
Creates dynamic translation rules that are applied to a source address when routing a
packet from the outside network to the inside network, and used for translating the
destination address when a packet returns to the outside network from the inside network.
The no version removes the dynamic translation rule.
NOTE: This command does not remove any dynamic translations from the translation
table.
accessListName—Name of the access list that you want to use for this dynamic
translation
poolName—Name of the NAT IP address pool that contains addresses you want to
use when translating matched access list addresses
Global Configuration
Copyright © 2010, Juniper Networks, Inc.