Ip Dvmrp Accept-Filter - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

JunosE 11.2.x Command Reference Guide A to M

ip dvmrp accept-filter

Syntax
Release Information
Description
Options
Mode
780
[ no ] ip dvmrp accept-filter listName1 [ distance ] neighbor-list listName2
Command introduced before JunosE Release 7.1.0.
Filters incoming DVMRP reports in accordance with a standard IP access list. The no
version disables the filter.
listName1—Name of the IP access list. If the name is 0, the interface accepts all
destinations. You can specify a simple or extended access list; with an extended access
list you can specify an address and a subnet mask.
distance—Number in the range 0–255; default value is 0; the distance associated with
the DVMRP route when the router determines the RPF interface for the source of a
multicast packet
listName2—Name of an access list containing the neighbors from which the router will
accept reports. If the name is 0, the interface accepts destinations from all its neighbors.
Interface Configuration
Copyright © 2010, Juniper Networks, Inc.