Ip Nat - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
ip nat
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
[ no ] ip nat { inside | outside }
Command introduced before JunosE Release 7.1.0.
Marks interfaces that participate in NAT translation as residing on the inside or the outside
network. The no version unmarks the interface so that it does not participate in NAT
translation.
inside—Specifies that the interface resides on the inside (private) portion of the network.
The inside portion of the network uses nonroutable IP addresses.
outside—Specifies that the interface resides on the outside (public) portion of the
network. The outside portion of the network (for example, the Internet) uses routable
legitimate addresses.
Interface Configuration, Profile Configuration
Chapter 10: I Commands
865
Advertisement
Table of Contents
