Ip Mac-Validate - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
ip mac-validate
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
ip mac-validate [ strict | loose ]
no ip mac-validate
Command introduced before JunosE Release 7.1.0.
Enables MAC address validation on a per interface basis. When MAC address validation
is enabled, the router checks the entry in the MAC validation table that corresponds to
the IP source address of an incoming packet. The MAC source address of the packet
must match the MAC source address of the table entry for the router to forward the
packet. The no version disables the feature.
strict—Prevents transmission of IP packets that do not reside in the validation table
loose—Allows IP packets to pass through even though the packets do not have entries
in the validation table; only packets that have matching IP–MAC pair entries in the
table are validated; this is the default setting
Interface Configuration
Chapter 10: I Commands
845
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 and is the answer not in the manual?
Questions and answers