Mpls-Relay Atm Cell-Packing Mcpt-Timer - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

mpls-relay atm cell-packing mcpt-timer

Syntax
Release Information
Description
Options
Mode
Related Topics
Copyright © 2010, Juniper Networks, Inc.
mpls-relay atm cell-packing maxCellsPerPacket mcpt-timer timerIdentifier
no mpls-relay atm cell-packing
Command introduced in JunosE Release 10.2.0.
Configures cell concatenation parameters for an ATM port to calculate the maximum
number of ATM cells that the router can concatenate in a single packet and the unique
identifier of the ATM Martini cell packing timer that you want to use to detect timeout of
the cell collection threshold. You can configure this command on the ATM port only after
you associated a pseudowire with the port by using the mpls-relay or route interface
tunnel command. You can use this command only on an ATM port (ATM AAL5 over ATM
major interface). The no version disables cell concatenation, which is the default behavior.
atm—Configures ATM interface parameters for MPLS cross-connect
maxCellsPerPacket—Maximum number of ATM cells in the range 1–190 that the router
can concatenate in a single VCC cell relay-encapsulated packet and transmit on an
MPLS pseudowire connection; default value is 1 cell per packet
timerIdentifier—Integer in the range 1–3 that identifies which of the three ATM Martini
cell packing timers (timer 1, timer 2, or timer 3) you want to use to detect timeout of
the cell collection time threshold; default value is 1. When the timer expires, the router
forwards the packet even if the number of concatenated ATM cells in the packet is
fewer than the specified maximum number of cells per packet.
Interface Configuration
Multiple ATM Virtual Circuits over a Single Pseudowire Overview and Multiple ATM Virtual
Circuits over a Single Pseudowire Example in the JunosE BGP and MPLS Configuration
Guide
Chapter 13: M Commands
1387