Ip Vrf - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
JunosE 11.2.x Command Reference Guide A to M
ip vrf
Syntax
Release Information
Description
Options
Mode
964
ip vrf vrfName
no ip vrf vrfName [ wait-for-completion [ waitSeconds ] ]
Command introduced before JunosE Release 7.1.0.
Creates a VRF or accesses VRF Configuration mode to configure a VRF. The no version
deletes the VRF.
NOTE: After creating the VRF, you must configure a route distinguisher for it via the rd
command; otherwise, the VRF will not operate.
vrfName—Name of the VRF; a string of 1–32 alphanumeric characters
wait-for-completion—Specifies (in the absence of waitSeconds) that the CLI waits for
completion of the no version operation before it returns a prompt, regardless of how
long that takes
waitSeconds—Number of seconds in the range 1–64000 that the CLI waits before it
returns a prompt, regardless of whether the no version operation has completed
Global Configuration
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
