Mpls Ldp Ip-Forwarding - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

mpls ldp ip-forwarding

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
[ no ] mpls ldp ip-forwarding [ { access-list | prefix-list } listName ) ] [ host-only ]
Command introduced in JunosE Release 7.1.0.
Specifies LSPs to be put into the IP routing table for forwarding plain IP traffic. The no
version removes the listed LSPs or all LSPs from the IP routing table.
NOTE: This command replaces the deprecated mpls topology-driven-lsp ip-interfaces
command.
NOTE: Although the carriage return, <cr>, option is displayed when you type a question
mark (?) after entering the mpls ldp ip-forwarding command, this command takes
effect only if the access-list, host-only, or prefix-list keyword, or a combination of them
is specified. Otherwise, although the command is configured successfully and no error
is displayed, labels are not used in the IP routing table for forwarding plain IP traffic.
This behavior for this command began in JunosE Release 7.1.0, in which the command
was introduced.
access-list—Specifies that listName is an access list
prefix-list—Specifies that listName is a prefix list
listName—Name of access list or prefix list that specifies LSPs over which IP interfaces
are created
host-only—Specifies that IP interfaces are created only over LSPs to host addresses
Global Configuration
Chapter 13: M Commands
1355