Ip Ignore-Df-Bit - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
ip ignore-df-bit
Syntax
Release Information
Description
Mode
Copyright © 2010, Juniper Networks, Inc.
[ no ] ip ignore-df-bit
Command introduced before JunosE Release 7.1.0.
Specifies that the router ignores the don't-fragment bit if present in the IP header of
packets crossing the configured interface; the router then fragments packets even if the
bit is present. The no version restores the default behavior, which is to consider the DF
bit before fragmenting.
Interface Configuration, Profile Configuration
Chapter 10: I Commands
835
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 and is the answer not in the manual?
Questions and answers