L2Tp Tunnel Default-Receive-Window - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
JunosE 11.2.x Command Reference Guide A to M
l2tp tunnel default-receive-window
Syntax
Release Information
Description
Options
Mode
1184
l2tp tunnel default-receive-window receiveWindowSize
no l2tp tunnel default-receive-window
Command introduced before JunosE Release 7.1.0.
Configures the default L2TP receive window size (RWS) for a tunnel on both the LAC
and the LNS. The RWS is the number of packets that the peer can transmit without
receiving an acknowledgment from the router. This command affects only those tunnels
configured on the router after the command is issued; it has no effect on previously
configured tunnels. The no version restores the default behavior, in which the router
chooses the default RWS.
receiveWindowSize—Default receive window size, in packets; currently, the only
supported value is 4
Global Configuration
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
