Ip Igmp-Proxy V1-Router-Present-Time - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
ip igmp-proxy V1-router-present-time
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
ip igmp-proxy V1-router-present-time seconds
no ip igmp-proxy V1-router-present-time
Command introduced before JunosE Release 7.1.0.
Specifies how long the router assumes that there is an IGMPv1 querier router on the
subnet after the router receives an IGMP V1 query on this interface. The no version restores
the default value, 10 seconds.
seconds—Time for which the router assumes that there is an IGMPv1 querier router on
the subnet after the router receives an IGMP V1 query on this interface
Interface Configuration
Chapter 10: I Commands
823
Advertisement
Table of Contents
