Description - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
description
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
description name
no description
Command introduced before JunosE Release 7.1.0.
In Controller Configuration mode, assigns a text description or an alias to a CT3, E3, T3,
or SONET/SDH interface. Use the show controllers e3, show controllers sonet, show
controllers t1, or mpls rsvp disable command to display the description. The no version
removes the description or alias.
In VRF Configuration mode, assigns a text description or an alias to the VRF. The no
version removes the description or alias.
NOTE: In Interface Configuration mode, this command has been replaced by the ip
description command for assigning a description to a static IP interface. This command
may be removed completely from Interface Configuration mode in a future release.
name—Text string or alias of up to 256 characters (in Interface Configuration mode)
or up to 80 characters (in Controller Configuration mode and VRF Configuration mode)
Controller Configuration, Interface Configuration, VRF Configuration
Chapter 5: D Commands
505
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 and is the answer not in the manual?
Questions and answers