Isis Hello-Interval - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
isis hello-interval
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
isis hello-interval seconds [ level-1 | level-2 ]
no isis hello-interval [ seconds ] [ level-1 | level-2 ]
Command introduced before JunosE Release 7.1.0.
Specifies the length of time in seconds between hello packets that the router sends on
the specified interface. The no version restores the default value.
seconds—Time (in the range 0–65535 seconds) equal to the hello multiplier times the
hello interval seconds; default value is 10 seconds.
level-1—Sets the hello interval for level 1 independently
level-2—Sets the hello interval for level 2 independently
Interface Configuration, Subinterface Configuration
Chapter 10: I Commands
1119
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 and is the answer not in the manual?
Questions and answers