Enable Secret - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

JunosE 11.2.x Command Reference Guide A to M

enable secret

Syntax
Release Information
Description
Options
Mode
558
enable secret [ level securityLevel ] [ secretType ] secretText
no enable secret [ securityLevel ]
Command introduced before JunosE Release 7.1.0.
Sets a secret to control access to certain types of commands. The no version removes
the secret requirement.
NOTE: On the E Series router, all secrets are stored as encrypted secrets.
securityLevel—Security level for which you want to set the secret; default value is 5
0—Allows the user to execute the help, enable, disable, and exit commands
1—Allows the user to execute commands in User Exec mode plus commands at level
0
5—Allows the user to execute Privileged Exec show commands plus the commands
at levels 1 and 0; this is the default level
10—Allows the user to execute all commands except support commands, which
may be provided by Juniper Networks Customer Service
15—Allows the user to execute support commands
secretType—One of the following:
0—Indicates that the secret is unencrypted; this is the default
7—Indicates that the secret is encrypted
secretText—Secret, either encrypted or unencrypted, depending on the secret type
Global Configuration
Copyright © 2010, Juniper Networks, Inc.