JunosE 11.2.x Command Reference Guide A to M
hello hold-time
Syntax
Release Information
Description
Options
Mode
680
hello hold-time seconds
no hello hold-time
Command introduced before JunosE Release 7.1.0.
Configures the MPLS hold time, the period that a sending LSR maintains a record of link
hello messages from the receiving LSR without receipt of another link hello from that
LSR. Each LSR peer sends the hold time in its link hello messages; peers negotiate to use
the minimum of the hold times proposed by all LSRs on the same subnet. The hold timer
is restarted whenever the LSR receives a link hello from the adjacent peer. The timer
expires if no link hello is received from the adjacent peer within the hold time. The LSR
deletes the link hello adjacency when the timer expires. If all link hello adjacencies are
deleted for an LDP session, then the LSR terminates the LDP session. The no version
restores the default value, 15 seconds.
seconds—Number of seconds, in the range 1–65535
LDP Profile Configuration
Copyright © 2010, Juniper Networks, Inc.