Mpls Lsp Retry-Time - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
mpls lsp retry-time
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
mpls lsp retry-time retryTime
no mpls lsp retry-time
Command introduced before JunosE Release 7.1.0.
Specifies the interval in seconds between attempts to set up an LSP for RSVP-TE after
a failure other than one due to no available route. The no version restores the default
value, 5 seconds.
retryTime—Interval in the range 1–60
Global Configuration
Chapter 13: M Commands
1375
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 and is the answer not in the manual?