Enable Password - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

JunosE 11.2.x Command Reference Guide A to M

enable password

Syntax
Release Information
Description
Options
Mode
556
enable password [ level securityLevel ] [ passwordType ] passwordText
no enable password [ level securityLevel ]
Command introduced before JunosE Release 7.1.0.
Sets a password to control access to certain types of commands. The no version removes
the password requirement.
NOTE: On the E Series router, all passwords are stored as encrypted passwords.
securityLevel—Security level for which you want to set the password; default value is
5; commands generally fall into one of the following security/privilege levels:
0—Allows the user to execute the help, enable, disable, and exit commands
1—Allows the user to execute commands in User Exec mode plus commands at level
0
5—Allows the user to execute Privileged Exec show commands plus the commands
at levels 1 and 0; this is the default level
10—Allows the user to execute all commands except support commands, which
may be provided by Juniper Networks Customer Service
15—Allows the user to execute privilege setting and support commands
passwordType:
0—Specifies that an unencrypted password follows; this is the default
7—Specifies that an encrypted password follows
passwordText—Password, either encrypted or unencrypted, depending on the password
type
Global Configuration
Copyright © 2010, Juniper Networks, Inc.