Ip Pim Send-Rp-Announce - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
ip pim send-rp-announce
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
ip pim send-rp-announce interfaceType interfaceSpecifier scope ttl
[ group-list ipAccessList] [ interval seconds ]
no ip pim send-rp-announce interfaceType interfaceSpecifier [ scope ttl ]
[ group-list ipAccessList ] [ interval seconds ]
Command introduced before JunosE Release 7.1.0.
Sends autoRP announcement messages from a router you configured as an RP. The no
version clears the specified filters from this interface.
interfaceType—Interface type; see Interface Types and Specifiers on page 5
interfaceSpecifier—Particular interface; format varies according to interface type; see
"Interface Types and Specifiers" on page 5. The autoRP announcement messages
will contain the IP address for this interface.
ttl—Time-to-live value; the number of hops for which the announcement is valid in the
range 1–65535; default value is 64 hops
ipAccessList—Name of the IP access list that specifies which multicast groups use this
RP; default value is no access list
seconds—Time interval in the range 1–65535 seconds at which the router sends the
announcements; default value is 60 seconds
Global Configuration
Chapter 10: I Commands
899
Advertisement
Table of Contents
