Ip Ospf Message-Digest-Key Md5 - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
JunosE 11.2.x Command Reference Guide A to M
ip ospf message-digest-key md5
Syntax
Release Information
Description
Options
Mode
882
ip ospf message-digest-key keyID md5 [ 0 | 8 ] msgDigestKey
no ip ospf message-digest-key keyID
Command introduced before JunosE Release 7.1.0.
Enables OSPF MD5 authentication and configures the MD5 key. The no version deletes
an MD5 key.
NOTE: If all the MD5 keys have been deleted, the authentication type is still MD5, but
you must configure MD5 keys.
To disable MD5 authentication for the interface, use the ip ospf authentication-none
command.
To display the password only in encrypted text, use the service password-encryption
command.
keyID—Key identifier in the range 1–255
md5—Specifies use of the MD5 algorithm
0—Indicates the msgDigestKey is entered in unencrypted form (plaintext); this is the
default option
8—Indicates the msgDigestKey is entered in encrypted form (ciphertext)
msgDigestKey—OSPF password; string of up to 16 alphanumeric characters
Interface Configuration, Subinterface Configuration
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
