Ipv6 Pim Join-Prune-Interval - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
ipv6 pim join-prune-interval
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
ipv6 pim join-prune-interval interval
no ipv6 pim join-prune-interval
Command introduced in JunosE Release 10.0.0.
Specifies the time interval at which the router sends the PIM join/prune message to the
upstream RPF neighbor. In Interface Configuration mode, the no version restores the
value that is specified in Router Configuration mode. If the message interval is not specified
in Router Configuration mode, then the default value of 60 seconds is restored.
NOTE: You cannot configure the designated router priority on PIM dense mode
interfaces.
interval—Interval in the range 10–210 seconds at which the router sends the PIM
join/prune message; the default value is 60 seconds.
Interface Configuration, Router Configuration
Chapter 10: I Commands
1087
Advertisement
Table of Contents
