Isis Hello-Multiplier - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

JunosE 11.2.x Command Reference Guide A to M

isis hello-multiplier

Syntax
Release Information
Description
Options
Mode
1120
isis hello-multiplier multiplier [ level-1 | level-2 ]
no isis hello-multiplier [ multiplier | level-1 | level-2 ]
Command introduced before JunosE Release 7.1.0.
Specifies the number of IS-IS hello packets a neighbor must miss before the router
declares the adjacency to be down. The no version restores the multiplier default value,
3.
multiplier—Value (in the range 3–1000) that the router uses as the hello-multiplier
when calculating the advertised hold time. The default multiplier value is 3.
level-1—Sets the hello-multiplier independently for level 1 adjacencies
level-2—Sets the hello-multiplier independently for level 2 adjacencies
Interface Configuration, Subinterface Configuration
Copyright © 2010, Juniper Networks, Inc.