L2Tp Drain Tunnel - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
l2tp drain tunnel
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
[ no ] l2tp drain tunnel { destinationName |
[ virtual-router vrName ] ip ipAddress tunnelName }
Command introduced before JunosE Release 7.1.0.
Prevents the assignment of new sessions to a tunnel. This command works in conjunction
with the l2tp shutdown tunnel command. Both commands affect the status of the
administrative state of L2TP for the tunnel; the l2tp drain tunnel command sets the
administrative state to drain. The no version allows the assignment of new sessions to
a tunnel.
destinationName—Name the router assigns to the LNS
vrName—Name of the virtual router on which the tunnel exists
ipAddress—IP address of the LNS
tunnelName—Name of the tunnel
Global Configuration
Chapter 12: L Commands
1167
Advertisement
Table of Contents
