Ipv6 Nd Ra-Lifetime - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
ipv6 nd ra-lifetime
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
ipv6 nd ra-lifetime seconds
no ipv6 nd ra-lifetime
Command introduced before JunosE Release 7.1.0.
Profile Configuration mode added in JunosE Release 9.0.0.
Specifies the router lifetime value in IPv6 router advertisements on an interface. The
router lifetime value is the amount of time the router is considered the default router on
this interface. The no version restores the default router lifetime value, 1800 seconds.
seconds—Number of seconds this router is considered the default router on this
interface; in the range 0–1800. A value of zero (0) indicates that this router is not a
default router on this interface. Nonzero values indicate that the router is a default
router on this interface. Nonzero values should not be less than the router advertisement
interval.
Interface Configuration, Profile Configuration
Chapter 10: I Commands
1067
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 and is the answer not in the manual?
Questions and answers