Cost - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
cost
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
cost intfCost
no cost
Command introduced before JunosE Release 7.1.0.
Specifies a cost metric for an OSPF remote-neighbor interface. Used in the calculation
of the SPF routing table. The no version restores the default value.
intfCost—Link-state metric cost; a number in the range 1–65535; default value is 10 if
there is no route to the remote neighbor; otherwise, the default is calculated based on
the bandwidth of the physical interface used to reach the remote neighbor and the
OSPF auto-cost reference bandwidth
Remote Neighbor Configuration
Chapter 4: C Commands
465
Advertisement
Table of Contents
