Diag-Level - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
diag-level
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
diag-level [ normal ] [ bypass ]
Command introduced in JunosE Release 9.2.0.
Sets the diagnostics level on the active or standby SRP module to reduce boot time
during a cold and a warm boot. The default diagnostics level is normal. There is no no
version.
normal—executes full diagnostics on the boot of the line card
bypass—skips diagnostic tests on the boot of the line card
Global Configuration
Chapter 5: D Commands
513
Advertisement
Table of Contents
