Existence-Test - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
existence-test
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
existence-test { event eventOwner eventName |
startup { absent | present } | test-type { absent | changed | present } }
no existence-test [ event | startup | test-type ]
Command introduced before JunosE Release 7.1.0.
Defines existence test values for the trigger that you are configuring, including binding
an event to the existence-test trigger, specifying a startup condition, and defining an
existence-test type. The no version deletes the existence-test values for this trigger or
removes either the startup condition or event binding.
eventOwner—Name of event owner that partially specifies event to trigger the existence
test; string of up to 32 alphanumeric characters
eventName—Name of event that partially specifies event to trigger the existence test;
string of up to 32 alphanumeric characters
startup—Specifies startup existence condition that you predict the sample to follow;
absent or present; you can specify both conditions in the same command
test-type—Specifies type of existence test to perform; absent, changed, or present;
you can specify one, two, or all three conditions in the same command
SNMP Trigger Configuration
Chapter 6: E Commands
609
Advertisement
Table of Contents
