Mount - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

mount

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
mount { disk0 | disk1 }
no mount { disk0 | disk1 } [ force ]
Command introduced in JunosE Release 8.0.0.
Mounts the specified flash card. If the card was not safely unmounted previously, the
command also performs disk and file system integrity checks before mounting the card
and permitting user access. The no version prepares the card for safe unmounting by
rejecting requests to open files and waiting for currently open files to close; only then is
the user notified that the unmounted card can be safely ejected.
disk0—Specifies flash card in slot 0 of the SRP module; although this option is displayed
by the CLI, it is rejected when specified because disk0 is required for router operation
disk1—Specifies flash card in slot 1 of the SRP module; supported only on the E120
router and the E320 router
force—Forces the dismount even when files on the disk are open for modification
Privileged Exec
Chapter 13: M Commands
1325