Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual page 1057

Mode
Related Topics
Copyright © 2010, Juniper Networks, Inc.
portOperator—One of the following classifier parameters. See Creating or Modifying
Classifier Control Lists for IPv6 Policy Lists for details.
lt—Less than
gt—Greater than
eq—Equal to
ne—Not equal
range—Range of port numbers
portNumber—Port number of the source or destination port
For TCP only:
tcpFlag; a logic equation that specifies flag bit values; ! means logical NOT and &
means logical AND; use any of the following flag names:
ack—0x10
fin—0x01
psh—0x08
rst—0x04
syn—0x02
urg—0x20
For ICMPv6:
icmpType—ICMP message type
icmpCode—ICMP message code
classifierNumber—Index of the classifier control list entry to be deleted
NOTE: The local-input keyword for the ipv6 policy command is deprecated, and may
be completely removed in a future release. The keyword should be removed from scripts.
You should recreate any local input policies using the ipv6 classifier-list local true
command and attaching the policies using the ipv6 policy secondary-input command.
Global Configuration
Creating or Modifying Classifier Control Lists for IPv6 Policy Lists
Chapter 10: I Commands
1013