Ip Sa-Validate - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
ip sa-validate
Syntax
Release Information
Description
Mode
Copyright © 2010, Juniper Networks, Inc.
[ no ] ip sa-validate
Command introduced before JunosE Release 7.1.0.
Enables source address validation on an interface. This feature verifies that a packet has
been sent from a valid source address. When a packet arrives on an interface, the router
performs a routing table lookup using the source address. The result from the routing
table lookup is an interface to which packets destined for that address are routed. This
interface must match the interface that the packet arrived on. If it does not match, the
router drops the packet. The no version disables source address validation.
Interface Configuration, Profile Configuration
Chapter 10: I Commands
937
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 and is the answer not in the manual?
Questions and answers