Ip Dhcp-Server - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
ip dhcp-server
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
ip dhcp-server dhcpServerAddress [ adminStatus ]
no ip dhcp-server [ dhcpServerAddress [ adminStatus ] ]
Command introduced before JunosE Release 7.1.0.
Adds the IP address of a single DHCP server to the list of DHCP servers from which the
router can request addresses to allocate to remote users. A maximum of five DHCP
servers can be specified. The no version removes the specified DHCP server or removes
all DHCP servers from the list.
dhcpServerAddress—IP address of the DHCP server that will allocate addresses for
remote users
adminStatus—One of the following options:
disable—Disables the DHCP server
drain—Drains the DHCP server
Global Configuration
Chapter 10: I Commands
773
Advertisement
Table of Contents
