Ip Igmp Query-Max-Response-Time - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
ip igmp query-max-response-time
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
ip igmp query-max-response-time tenthsOfaSecond
no ip igmp query-max-response-time
Command introduced before JunosE Release 7.1.0.
Specifies the period in tenths of a second during which the host is expected to respond
to an IGMP query. IGMP version 2 includes this value in IGMP query messages sent out
on the interface. You cannot set this value on interfaces running IGMP version 1. The no
version restores the default value, 100 tenths of a second (10 seconds).
tenthsOfaSecond—Time interval between receipt of an IGMP query and the response;
in the range 1–254 tenths of a second.
Interface Configuration, Profile Configuration
Chapter 10: I Commands
827
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 and is the answer not in the manual?
Questions and answers