Mpls Ldp Redistribute - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

mpls ldp redistribute

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
mpls ldp redistribute protocol [ route-map mapName ]
no mpls ldp redistribute protocol [ route-map mapName ]
Command introduced in JunosE Release 7.1.0.
Enables redistribution of routes from the specified IGP to LDP, enabling LDP to advertise
labeled BGP routes for the inter-AS option C two-stack scenario. The no version halts
redistribution from the specified IGP or according to the specified route map.
You can specify a route map to redistribute more specific routes to LDP. Only routes that
pass the maps clauses are redistributed. If you do not use a route map for fine-grained
control of route distribution, and you do not want to redistribute BGP routes, then you
do not need to issue this command.
For backward compatibility, if you do not issue this command, LDP continues to advertise
labels for IGP routes—including connected, static, IS-IS, OSPF, and RIP routes, but
excluding BGP routes. That is, IGP routes other than BGP are redistributed to LDP by
default.
protocol—Protocol from which routes are redistributed to LDP: BGP, connected, IS-IS,
OSPF, RIP, or static
mapName—Name of the route map used to redistribute more specific routing
information from an IGP to LDP
Global Configuration
Chapter 13: M Commands
1359