Mpls-Relay Disable - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
mpls-relay disable
Syntax
Release Information
Description
Mode
Copyright © 2010, Juniper Networks, Inc.
[ no ] mpls-relay disable
Command introduced in JunosE Release 7.1.0.
Administratively disables the MPLS shim interface. The MPLS shim interface must exist
before this command can be issued. MPLS shim interfaces are administratively enabled
by default. The no version restores the default condition.
Interface Configuration
Chapter 13: M Commands
1389
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 and is the answer not in the manual?