L2Tp Policy - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

JunosE 11.2.x Command Reference Guide A to M

l2tp policy

Syntax
Release Information
Description
Options
Mode
Related Topics
1172
l2tp policy { input | output } policyName [ statistics
{ enabled | disabled } [ merge ]
no l2tp policy { input | output }
Command introduced before JunosE Release 7.1.0.
merge keyword added in JunosE Release 7.2.0.
Assigns an L2TP policy list to a profile, which then assigns the policy to an interface. If
you enter the l2tp policy command and the policy list does not exist, the router creates
a policy list with no rules, the default. Attaching this policy list to an interface filters all
packets on that interface. You must specify the input or output keyword to assign the
policy list to the ingress or egress of the interface. The no version removes the association
between a policy list and a profile.
input—Applies policy to data arriving at the interface
output—Applies policy to data leaving the interface
policyName—Name of the policy; maximum of 40 characters
statistics—Enables or disables collection of policy routing statistics
enabled—Enables collection of policy routing statistics
disabled—Disables collection of policy routing statistics
merge—Enables merging of multiple policies to form a single policy
Profile Configuration
Setting a Statistics Baseline for Policies
Copyright © 2010, Juniper Networks, Inc.