Ipv6 Ospf Mtu-Ignore - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
ipv6 ospf mtu-ignore
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
[ no ] ipv6 ospf [ processId ] mtu-ignore
Command introduced before JunosE Release 7.1.0.
Specifies that the interface ignore the MTU size contained in the DBD packet. The interface
accepts data description packets from its neighbor even if it has a different a MTU size.
However, the MTU size must be less than 18000. The no version resets the default; that
the neighbor MTU size must match the MTU size of the OSPFv3 interface from which
the packet is received.
processId—Integer in the range 1–65535
Interface Configuration, Subinterface Configuration
Chapter 10: I Commands
1077
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 and is the answer not in the manual?
Questions and answers