Mpls Rsvp Authentication - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
mpls rsvp authentication
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
[ no ] { ip | mpls } rsvp authentication
Command introduced before JunosE Release 7.1.0.
Enables MD5 authentication for RSVP on the interface. Enable authentication after
configuring the authentication key. The router generates an error message and discards
any RSVP messages if you enable authentication before configuring the authentication
key, or remove the key while authentication is still enabled. The no version disables
authentication.
ip—Specifies alternative keyword for compatibility with non–E Series implementations
mpls—Specifies JunosE MPLS implementation
Interface Configuration
Chapter 13: M Commands
1393
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 and is the answer not in the manual?
Questions and answers