Ip Vrrp Icr-Partition Vlan-List - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
ip vrrp icr-partition vlan-list
Syntax
Release Information
Description
Options
Mode
Related Topics
Copyright © 2010, Juniper Networks, Inc.
ip vrrp vrid icr-partition vlan-list [ vlanIdValue ] *
[ use-default-mac ] [ control-interface ] [ advertise-mac ]
no ip vrrp vrid icr-partition vlan-list [ vlanIdValue ] *
Command introduced in JunosE Release 10.3.0.
Adds a VLAN to the ICR partition. You can assign only unique VLANs to the partition. If
you attempt to assign a previously assigned VLAN to the ICR partition, the router displays
an error message. You can assign VLANs only if you have selected VLAN based grouping
by using the ip vrrp icr-partition group command. The no version deletes the VLAN from
the ICR partition.
NOTE: You can use the listed optional parameters only when you add a VLAN to the
ICR partition. You cannot modify an existing subinterface using these parameters. You
can specify the optional parameters in any order.
vrid—VRID identifier; a number in the range 1–255
vlanIdValue—VLAN identifier; a number in the range 0–4095
use-default-mac—Configures the VLAN to use the default MAC address. By default,
the router assigns the VRRP media access control (MAC) address to all subinterfaces
of the ICR partition.
control-interface—Controls traffic on a subinterface that is part of a backup partition.
When you use this option, the router changes the state of the corresponding
subinterface to Admindown. When the subinterface is in Admindown state, the router
blocks all traffic to the interface. However, the router does not block advertisements
as long as VRRP is running on a separate subinterface. The router changes the state
of the subinterface from Admindown to Up when the state of the partition changes
from backup to master.
advertise-mac—Enables the subinterface to transmit GARP advertisements when the
partition moves from backup state to master state. By default, GARP advertisements
are blocked on subinterfaces.
Interface Configuration, Subinterface Configuration
Grouping ICR Subscribers Based on VLAN IDs
Configuring an ICR Partition
Chapter 10: I Commands
977
Advertisement
Table of Contents
