Configure - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
configure
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
configure [ terminal | file [ fileName ] [ verbose | show-progress [ dotPeriod ] ] ]
Command introduced before JunosE Release 7.1.0.
Enters Global Configuration mode. There is no no version.
NOTE: This command is not allowed for a short time after a warm restart (warm
switchover) occurs. This behavior allows some applications time to complete their
warm-restart initialization. However, if the warm-restart does not complete in 5 minutes,
the warm-start is cancelled and configuration access is restored.
terminal—Enables manual configuration from a terminal
file—Configures the router from a script file
fileName—Script file to execute
verbose—Echoes each command as the script is executed
show-progress—Displays a '.' during script execution
dotPeriod—Number of commands executed before a '.' is displayed; default value is
100
Privileged Exec
Chapter 4: C Commands
447
Advertisement
Table of Contents
