Lease - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
lease
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
lease { days [ hours [ minutes [ seconds ] ] ] | infinite }
no lease
Command introduced before JunosE Release 7.1.0.
Specifies the time period for which the supplied IP address is valid. The no version restores
the default lease time, 30 minutes.
NOTE: Ensure that DHCP clients have a minimum lease of 120 minutes before you begin
a unified in-service software upgrade to prevent unwanted lease expirations due to the
length of the unified ISSU process.
days—Number of days for which the IP address is valid; in the range 0–32768
hours—Number of hours for which the IP address is valid in the range 0–24
minutes—Number of minutes for which the IP address is valid; in the range 0–60
seconds—Number of seconds for which the IP address is valid; in the range 0–60
infinite—Assigns a lease that does not expire
DHCP Local Pool Configuration
Chapter 12: L Commands
1203
Advertisement
Table of Contents
