Ipsec Option Nat-T - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
ipsec option nat-t
Syntax
Release Information
Description
Mode
Copyright © 2010, Juniper Networks, Inc.
[ no | default ] ipsec option nat-t
Command introduced before JunosE Release 7.1.0.
Enables IPSec Network Address Translation Traversal (NAT-T) for the current virtual
router. With NAT-T enabled, IPSec traffic flows transparently through a NAT device,
thereby allowing one or more remote hosts located behind the NAT device to use secure
L2TP/IPSec tunnels to access the router. The ipsec option nat-t command affects only
IKE SAs negotiated on this virtual router after the command is issued; it has no effect on
previously negotiated IKE SAs. The no version disables NAT-T for the current virtual
router. The default version restores the default NAT-T setting, enabled.
Global Configuration
Chapter 10: I Commands
1001
Advertisement
Table of Contents
