Rear Parking Aid - Seat Leon 5D Owner's Manual

Manoeuvre braking function*
The emergency braking function is used to
minimise damage in the event of a collision.
Depending on the equipment, if the Parking
Aid is active, the braking while manoeuvring
function activates emergency braking when it
detects an obstacle in the vehicle's path that
could cause a collision, driving forwards or in
reverse.
The function will not brake if the Parking Aid is
activated automatically. For the system to
operate, manoeuvring speed must be be-
tween 2.5-7 km/h (1.5-4 mph) for the front
area and between 1.5-7 km/h (1-4 mph) for
the rear.
Following an intervention, the braking while
manoeuvring function will be inactive in the
same direction of travel for 5 metres. Once
the gear is changed, or the selector lever's
position is changed, the function will be ac-
tive again. The Parking Aid's limitations apply.
The braking while manoeuvring function is set
in the Infotainment system: function button
> Driver assistance> Parking aid.
Temporary suppression of emergency
braking
When the function is deactivated with the
●
Braking while manoeuvring button that ap-
pears on the Parking aid screen of the Info-
tainment system.
288
Driving
Whenever any of the car doors, rear lid or
●
bonnet are opened.

Rear parking aid*

Description
The rear parking aid is an optical and audi-
ble assistant that warns of obstacles located
behind the vehicle.
There are sensors integrated in the rear
bumper. When they detect an obstacle, you
are alerted by audible and visible warnings
on the Infotainment system.
Make particularly sure that the sensors are
not covered by adhesives, residues, dirt and
the like, as this could affect the system's op-
eration. Cleaning instructions
The approximate measurement range of the
rear sensors is:
Side area: 0.60 m
●

Central area: 1.60 m
●
As you approach the obstacle, the frequency
of the audible signals will increase. The signal
will sound continuously at around 0.30 m:
›››
Stop! in Introduction on page
›››
in Introduction on page
If the separation is maintained, the warning
volume is reduced after about 2.5 seconds.
Parking Aid connection
Select reverse gear.
●
Parking Aid disconnection
Drive forward at 15 km/h (9 mph) or faster.
●
OR: set the selector lever to P, N or D in ve-
●
hicles with automatic transmission.
Setting the indications and audio signals
The indications and acoustic signals are set
in the Infotainment system: function button
> Driver assistance> Parking aid.
Setup
Rear volume*
Adjust volume
›››
page 354.
Error messages
If a an error or fault message appears on the
instrument cluster in Park Assist, there is a
fault.
If the fault doesn't disappear before discon-
necting the ignition, it will not be indicated
284,
next time the parking aid is connected.
284!
We recommend taking the vehicle to a speci-
alised workshop to have the fault repaired.

Volume in the rear area.
When the parking aid is
switched on, the volume of
the audio source will be re-
duced, depending on the se-
lected option.