Tyre Pressure Monitor System - Seat Mii 2020 Owner's Manual

used. Rolling noise, wear and energy con-
sumption will all be reduced.
Snow chains
Snow chains should only be used on the
front wheels.
Check that they are correctly seated after
●
driving for a few yards; correct the position if
necessary, in accordance with the manufac-
turer's fitting instructions.
Keep your speed below 50 km/h (30 mph).
●
Snow chains will improve braking ability as
well as traction in winter conditions.
For technical reasons snow chains may only
be used with the following wheel rim/tyre
combination.
165/70 R14
Chains with links of maximum 15 mm
175/65 R14
Remove any central wheel trims and the rim
ring before fitting snow chains.
WARNING
The use of unsuitable or incorrectly fitted
chains could lead to serious accidents and
damage.
Always the appropriate snow chains.
●
192
Practical tips
Observe the fitting instructions provided
●
by the snow chain manufacturer.
Never exceed the maximum permitted
●
speeds when driving with snow chains.
CAUTION
Remove the snow chains to drive on
●
roads without snow. Otherwise they will im-
pair vehicle handling, damage the tyres
and wear out very quickly.
Wheel rims may be damaged or scratch-
●
ed if the chains come into direct contact
with them. SEAT recommends the use of
covered snow chains.
Tyre pressure monitor sys-
tem*
Control lamp
 It lights up
The tyre pressure of a wheel is much lower than the
›››
value set by the driver in Tyre pressure moni-
tor system* on page 193.
Several control and warning lamps light up
for a few seconds when the ignition is switch-
ed on while the function is verified. They will
switch off after a few seconds.
WARNING
›››
Observe the safety warnings
trol and warning lamps on page

Tyre pressure monitor system*

In the glove box: tyre pressure loss in-
Fig. 169
dicator button.
The tyre pressure loss indicator compares the
revolutions and thus the wheel diameter of
each wheel using the ESC. If the wheel diam-
eter of a wheel changes, the control indicator
of the tyres informs of this fact

diameter changes when:
Tyre pressure is insufficient.
●
The tyre structure is damaged.
●
The vehicle is unbalanced because of a
●
load.
in Con-
66.
. The wheel