Tyre Pressure Monitor System - Seat Ateca 2020 Owner's Manual

Snow chains
Snow chains must only be fitted to the front
wheels, even on vehicles with four-wheel
drive.
Check that they are correctly seated after
●
driving for a few yards; correct the position if
necessary, in accordance with the manufac-
turer's fitting instructions.
Keep your speed below 50 km/h (30 mph).
●
If there is a danger of being trapped de-
●
spite having mounted the chains, it is best to
disable the driving wheels (ASR) in the ESC
›››
page 270, Connecting and disconnect-
ing the ESC and ASR.
Snow chains will improve braking ability as
well as traction in winter conditions.
For technical reasons snow chains may only
be used with the following wheel rim/tyre
combination.
332
Practical tips
Tyres Wheel rim
215/60 R16 6Jx16 VAS 43
215/55 R17 7Jx17 VAS 45
215/50 R18 7Jx18 VAS 45
225/55 R17 7Jx17 VAS 45
225/50 R18 7Jx18 VAS 45
225/45 R19 8Jx19 VAS 45
Other dimensions do not allow chains
Remove any central wheel trims before fitting
snow chains.
WARNING
The use of unsuitable or incorrectly fitted
chains could lead to serious accidents and
damage.
Always the appropriate snow chains.
●
Observe the fitting instructions provided
●
by the snow chain manufacturer.
Never exceed the maximum permitted
●
speeds when driving with snow chains.
CAUTION
Remove the snow chains to drive on
●
roads without snow. Otherwise they will im-
pair vehicle handling, damage the tyres
and wear out very quickly.
Chains Wheel rims may be damaged or scratch-
●
ed if the chains come into direct contact
with them. SEAT recommends the use of
covered snow chains.
Max. link 15 mm
Tyre pressure monitor sys-
Max. link 9 mm tem
Control lamp
 It lights up
The inflation pressure of one or more wheels is much
lower than the value set by the driver, or the tyre has
structural damage.
In addition, a audible warning sounds and a text
message is displayed on the instrument panel
screen.
Stop the vehicle! Stop the vehicle safely as soon

as possible. Check all tyres and pressures. Replace
any damaged tyres.
 Flashes
System fault
The control lamp flashes for approximately 1 minute
and then lights up permanently.
If the tyre is inflated correctly, switch the ignition off
and on again. Re-calibrate the tyre pressure monitor
›››
indicator page
specialised workshop.
Several control and warning lamps light up
for a few seconds when the ignition is
333. If the fault continues, go to a