Sensors; Remove And Install Intake Manifold Sender Gx9; Removing And Installing Fuel Pressure Sensor G247 - Seat Leon 2013 Workshop Manual

4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
5

Sensors

⇒ "5.1 Remove and install intake manifold sender GX9 ",
page 235
⇒ "5.2 Removing and installing fuel pressure sensor G247 ", page
235
⇒ "5.3 Checking fuel pressure sender G247 ", page 236
5.1 Remove and install intake manifold
sender - GX9-
Intake manifold sender - GX9- is comprised of:
♦ Intake air temperature sender 2 - G299-
♦ Intake manifold pressure sender - G71-
Removing
– Remove air cleaner housing
– Disconnect electrical connector -arrow-.
– Release fasteners, and remove intake manifold sender -
GX9- .
Installation
Installation is carried out in the reverse order. Please note the
following:
Note
♦ Replace the O-ring.
If the retaining tabs broke off during removal, the sender can
♦
be secured using 2 fastening screws as per the ⇒ Electronic
parts catalogue . Tightening torque:
– Install air cleaner housing.
Specified torques
Component
Intake manifold sender - GX9-
5.2 Removing and installing fuel pressure
sensor - G247-
Special tools and workshop equipment required
♦ Assembly tool - T10118-
⇒ page 226 .
⇒ page 235 .
⇒ page 226
Tightening torque
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
3 Nm
respect to the correctness of information in this document. Copyright by SEAT S.A.
León 2013 ➤ , León ST 2013 ➤
235
5. Sensors