ABB IRB 1300 Product Manual page 66

3 Installation and commissioning
3.3.2 Manually releasing the brakes
Continued
3
Supplying power to connector R1.MP
If the robot is not connected to the controller, power must be supplied to connector
R1.MP on the robot, in order to enable the brake release buttons.
1
2
3
66
Action
The brake will be enable as soon as the button is
released.
Action
DANGER
Incorrect connections, such as supplying power
to the wrong pin, may cause all brakes to be
released simultaneously and instantly!
Supply
• 0V on pin 12.
• 24V on pin 11.
Note
Do not interchange the 24V and 0V pins.
If they are mixed up, damage can be caused to
internal electrical components.
Use the brake releasing button as described in
Releasing the brakes on page
© Copyright 2020-2022 ABB. All rights reserved.
Note
xx1900001653
Note
xx1900001654
65.
Product manual - IRB 1300
3HAC070390-001 Revision: G