ABB IRB 1300 Product Manual page 529

2
3
4
5
Refitting the motor
Use these procedures to refit the axis-3 motor.
Refitting the axis-3 motor
1
Product manual - IRB 1300
3HAC070390-001 Revision: G
Action
CAUTION
For robots with protection type Clean Room
Always cut the paint with a knife and grind the
paint edge when disassembling parts of the robot!
See Cut the paint or surface on the robot before
replacing parts on page 145.
CAUTION
Removing motors will release axes. This means
the axes can fall down.
Make sure axes are well supported before remov-
ing motors.
Remove the screws and washers.
Carefully lift out the motor.
Action
For robots with protection type Clean Room:
Clean the joints that have been opened and wipe
the parts free from particles with spirit on a lint
free.
© Copyright 2020-2022 ABB. All rights reserved.
5 Repair
5.6.3 Replacing the axis-3 motor
Continued
Note
xx2000001616
xx2000001617
Note
Continues on next page
529