ABB IRB 1300 Product Manual page 303

3
4
Disconnecting the axis-6 motor connectors
1
2
Product manual - IRB 1300
3HAC070390-001 Revision: G
Action
Cut the cable straps.
Remove the connector plates.
CAUTION
Be aware of the cablings that are attached to the
connector plate! The connector plate cannot be
removed completely until the connectors are re-
move from the plate.
Action
DANGER
Make sure that all supplies for electrical power,
hydraulic pressure, and air pressure are turned
off.
CAUTION
For robots with protection type Clean Room
Always cut the paint with a knife and grind the
paint edge when disassembling parts of the robot!
See Cut the paint or surface on the robot before
replacing parts on page 145.
© Copyright 2020-2022 ABB. All rights reserved.
5 Repair
5.5.1 Replacing the lower arm
Continued
Note
xx2000001530
xx2000001531
Note
Continues on next page
303