Cruise Control Command Switch - Subaru IMPREZA GD 2007 Series Manual

asieps_tobira_IM_US.book 5 ページ ２０１２年１月１７日 火曜日 午後３時４８分
3. Cruise Control Command
Switch
A: REMOVAL
WARNING:
Before servicing, be sure to read the notes in
the "AB" section for proper handling of the
driver's airbag module. <Ref. to AB-3, CAU-
TION, General Description.>
1) Set the front wheels in straight ahead position.
2) Turn the ignition switch to OFF.
3) Disconnect the ground cable from battery and
wait for at least 20 seconds before starting work.
®
4) Using TORX bit T30 (1), loosen two TORX
bolts which secure the driver's airbag module.
5) Disconnect the airbag module connector on
back of the airbag module.
6) Remove the steering wheel. <Ref. to PS-18, RE-
MOVAL, Steering Wheel.>
7) Remove the four screws to remove the lower
cover from steering wheel.
8) Remove one screw to remove the cruise control
command switch from lower cover.

Cruise Control Command Switch

B: INSTALLATION
Install in the reverse order of removal.
C: INSPECTION
Measure the cruise control command switch resis-
tance.
®
SET/COAST
(1)
RESUME/
CC-00018
If NG, replace the cruise control command switch.
CC-00309
CC-00182
CC-5
CRUISE CONTROL SYSTEM
2 1
5 4 3
Switch Position Terminal No.
ON 1 (+) and 2 (–)
CANCEL
ON 1 (+) and 3 (–)
OFF 1 and 2
ON 1 and 2
OFF 1 and 3
ACCEL
ON 1 and 3
OFF 5 and 4
MAIN
SWITCH
ON 5 and 4
CC-00288
Standard
Less than 1 Ω
Less than 1 Ω
1 MΩ or more
Less than 1 Ω
1 MΩ or more
Less than 1 Ω
1 MΩ or more
Less than 1 Ω