Subaru IMPREZA GD 2007 Series Manual page 3645

asieps_tobira_IM_US.book 102 ページ ２０１２年１月１７日 火曜日 午後３時４８分
AIRBAG SYSTEM (DIAGNOSTICS)
Step
5 CHECK AIRBAG MAIN HARNESS (DRIV-
ER'S AIRBAG HARNESS).
Measure the resistance between connector
(2R) terminals in the test harness R, and
between connector (2R) and chassis ground.
Connector & terminal
(2R) No. 2 — (2R) No. 4:
(2R) No. 4 — Chassis ground:
(2R) No. 2 — Chassis ground:
(2R) No. 8 — (2R) No. 12:
(2R) No. 8 — Chassis ground:
(2R) No. 12 — Chassis ground:
6 CHECK AIRBAG CONTROL MODULE.
1) Connect all connectors.
2) Erase the memory.
3) Perform the Inspection Mode.
4) Read the DTC.
7 CHECK FOR ANY OTHER DTC ON DISPLAY. Is any other DTC displayed?
Diagnostic Chart with Trouble Code
Is the resistance 1 MΩ or
more?
Is the same DTC displayed?
AB(diag)-102
Check Yes
Go to step 6.
Replace the airbag
control module.
<Ref. to AB-17,
Airbag Control
Module.>
Check DTC using
"List of Diagnostic
Trouble Code
(DTC)". <Ref. to
AB(diag)-43, List
of Diagnostic Trou-
ble Code (DTC).>
No
Replace the airbag
main harness
along with body
harness.
Go to step 7.
Finish the diagno-
sis.